| Sensitive dimmer
for metal appliance |
|||||
| Code
x0741 |
|||||
|
(Light
equipment spares) |
|||||
| 127 Volt | |||||
 |
 |
||||
 |
|||||
| Function: | |||||
| -
It allows turning on/off or altering by steps, the lighting intensity
of a metal frame. - Appropriate to be used in bureau equipment. It replaces the standard switch or torpedo. |
|||||
| Operation: | |||||
| - By touching slightly the appliance metal frame, the lam turns on at a low intensity level. If it is touched again, the light level gets high and in the end, if it is touched once more, the light goes off and so on. | |||||
| Installation: | |||||
| -
It should be installed, in the light appliance with metal body. The sensor
cable should be fixed to the metal frame. Check that the metal frame does
not discharge to ground. - Due to its polarity, if its running is not correct, it means that male plug polarity must be inverted. - To be used indoors only. - Before carrying out the installation,the general electric power switch of the entire premises must be shut off. |
|||||
| Wiring diagrams: | |||||
 |
|||||
| Technical features: | |||||
• Supply voltage: 127 V 
50 - 60 Hz.• It has radiofrequency filter to reduce interferences in communication, audio and tv equipment. • Oulet to triac. • class II device  • Indoore use  • Weigth: 20 gr. |
 |
||||
|
Maximum
and minimum power per load type: |
 Note: |
|||
 |
There
is another unit ( Cod.0743) that allows to adjust the level of luminosity
for continuous variation. |
||||
| Downloads: | |||||
| |
|||||
