Universal
photocontrol
with
programable Timed
with standard socket
1700 W
programable Timed
with standard socket
1700 W
Code
x0133
127Volt
(Suitable for any lamps)
-
It allows turning on a light appliance automatically and turning off.After
a set number of hours in this way, allows saving energy.
- Suitable for use in public way, aquares, factories , out of the house,
in windows-shops, shelters, posters, signs.
Operation:
- The initial programming
is 6 hours and takes place in manufacturing but it can be modified by
the installer through dip switch (small switches) found in its interior
and done by the installer.
- Next fully automatic operation.
Installation:
- Mount
on three polar standard socket.
- To install in the proximity of the device to control but avoiding bringht light falls on the fotocontrol.
- It can be installed outdoors but vertically.
- Before carrying out the installation,the general electric power switch of the entire premises must be shut off.
- To install in the proximity of the device to control but avoiding bringht light falls on the fotocontrol.
- It can be installed outdoors but vertically.
- Before carrying out the installation,the general electric power switch of the entire premises must be shut off.
Maximum
power per load type:
•
Supply voltage:
127 V 
50 - 60
Hz.
• Programmable temporisation: 2,3,4,6,8,12 hours
15 % from its
ignition.
• Relay ouput.
• class II device
• outdoor use
• IP 44.
• Weigth: 74 gr.
50 - 60
Hz.• Programmable temporisation: 2,3,4,6,8,12 hours
15 % from its
ignition.• Relay ouput.
• class II device
• outdoor use
• IP 44.
• Weigth: 74 gr.
| Warning  |
| • The light from any light appliance should be prevented from coming into contact with the photocontrol. |
- To control higher power a contactor should be used, with a photocontrol to supply the reel of the contactor.
Wiring
diagrams:
Downloads: