BACK
Photocontrol for DIN rail with
sensitivity and timing switch
1000 W
Code x0121
(Suitable for any lamps)
127 Volt
Function: 
- It allows turning on a light appliance automatically and turning it off at after a certain number of hours scheduled ( this helps to save energy).
- The model with sensitivity regulation allows adjusting at will the level of ambiance ligth (dusk).
- Suitable for use out of the dwelling house, in windows-shops, shelters, posters, signs, public way,aquares, factories.
Operación:
- The timed is scheduled through switches placed in the front. It can be made by the installator ( see programmation).
- Sensitivity is regulated through a potenciometer placed in the front.
- Next fully automatic operation.
Installation: 
- The main body of the photoncontrol should be installed into a box with DIN reel. (do not install outdoors).
- The sensor should be placed outside so that it gets most of the daylight , it can be installed outdoors but vertically ( if not outdoors, it can be installed in any position).
- Both bodies should be joint by a bipolar conductor with no less than 0,75 mm section, suitably isolated.
- Before carrying out the installation,the general electric power switch of the entire premises must be shut off.
Maximum power per load type:
 Programming:

- Choose the number of hours the load will be on during the night based on the following graph:

- From start 20 % to 25 ªC.
*TEMPORIZATION WITH WICH USINE DISPOSITIVE IS DELIVERED.
Wiring diagrams:
Technical features:  
Warning
• The light from any light appliance should be prevented from coming into contact with the photocontrol.


Note:
The light appliance should be kept away
from moisture and insects.
• Supply voltage: 127 V 50 - 60 Hz.
• Schedule timing: 2,3,4,6,8 and 12 hours 20 % from start. ( when there is ligth, timing stops).
• Sensivility adjustment: 0,1 to 6000 Lux.
• Relay ouput.
• class II device
• Main body indoore use
• Sensor:
• outdoor use
IP 44.
• Weigth: 120 gr. 
Downloads: