BACK
Universal motion detector
double module
with - 12 Vdc - Vac

5 A
Code s5101 to 23
Function:
- It allows to detect people`s motion within an area and to close the circuit for some time ( to be adjusted ), and open in later.
- To apply in installations that supply 12 V permanent or alternate voltage.
-It also allows to adjust, though an ambiance light intensity detector, the ambiance light threshold requiered.
-Suitable for the light control by corridors, stairs, garage, bath, etc, and where requiered by any other ambit for automatic opening for motion detection and timed closing purposes.It is also used to control the supply of any appliance that may comply with the technical characteristics of this unit.
Operation:
-Fully automatic operation.
Installation:
-To beinstalled in alight switch framework, assembled into an embedded rectangular box compatible with the model acquired. It takes up the places of a two modules.
-To be used indoors only.
-After the instalation, ignition time and ambiance light sensitivity should be adjusted with the corresponding preset device.
-Before carrying out the installation,the general electric power switch of the entire premises must be shut off.
Wiring diagrams:



Horizontal Vertical

Important: The maximum range is calculated considering the detection area transversely.
Maximum power per load type:
Warning
No alimentar con 220 Volt.
-Not to installin exposed places to important airflows, near sourses of heat or of cold.
Technical features:
• Supply voltage:12V - 50 Hz to 12V .
• Maximum power: 60 W ( With resistive load ) 30 VA ( With inductive load ).
• Maximum range: 6 meters (to 20º C)
• Detection angle: 140º ( horizontal ) 70º ( vertical ).
• On time: de 7,5 seg. 40 % to 6,5 min 40 %.
• Operation by ambiance light: de 0,1 a 6.000 lux.
• Oulet to Relay.
• class II device
• Indoore use
• Weigth: 60 gr.
 
Downloads: