BACK
Motion detector module
200 W
Code 2901 to 29
220 Volt
Function:
-It allows to detect people`s motion within an area and ignition the one or more lamps, for some time ( to be ajusted ), and close in later.
-It also allows to adjust, though an ambiance light intensity detector, the ambiance light threshold requiered.
-Suitable for the light control by corridors, stairs, garage, bath, etc, and where requiered by any other ambit for automatic opening for motion detection and timed closing purposes.It is also used to control the supply of any appliance that may comply with the technical characteristics of this unit.
Operation:
-Fully automatic operation.
Installation:
-To beinstalled in alight switch framework, assembled into an embedded rectangular box compatible with the model acquired. It takes up the places of a module.
-To be used indoors only.
-After the instalation, ignition time and ambiance light sensitivity should be adjusted with the corresponding preset device.
-Before carrying out the installation,the general electric power switch of the entire premises must be shut off.
Simple connection:
Automatic or permanent connection:
 

Important: The maximum range is calculated considering the detection area transversely.
Another presentation and model: 
WITH PLATE AND FRAME
Code 2927
SEMI - ASSEMBLED (OEM)
Code 2925
CIRCUIT
Code 2929
Technical features:
• Supply voltage: 220 V 50 - 60 Hz.
• Maximum range: 6 meters (to 20º C)
• Detection angle: 140º (horizontal) 70º (vertical)
• On time: de 7 seg. 40 % a 10,5 min 40 %.
• Operation by ambiance light: de 0,1 a 6.000 lux.
• Oulet to triac.
• class II device
• Indoore use
• Weigth: 30 gr.  
Warning
• Do not use with:
- Fluorescent tube.
- Dichroic lamps with not dimming
electronictransformer.
- Energy - efficient lamps.
- Discharge lamps.
- Mixer lamps.
- Not to install in exposed places to important airflows.
Maximum and minimum power per load type:
Downloads:
Download all the catalogue