BACK
corridor timer module
 2 - cable
Code 0951 to 79
(Manufactured for different lines and colors in the market.)
220 Volt
Function:
- It allows keeping ligthtingset, from an adjustable time on by pressing a standard auxiliary switch.
- Suitable for the light control of corridors, stairways, parking space and any other place, where requiered for manual ignition and timedturning - off purposes.It is also used to control the supply of any appliance that may comply with the technical characteristics of this unit.
Operation:
- It is operated by pressing manually the standard auxiliary switch, then timing turns off automatic.
Installation:
- To be installed in a ligth switch framework, assembled into an embedded rectangular box compatible with the model acquired. It takes up the place
of a module.
- Then some standard switches are conected in parallel to the unit, so as to operate as auxiliary switches.
- To be used indoors only.
- After the installation, start time should be adjusted with the corresponding preset controls located in its bottom.
- Before carrying out the installation,the general electric power switch of the entire premises must be shut off.
Wiring diagrams:
Technical features:
• Supply voltage: 220 V 50 - 60 Hz.
• Timing: adjustable with in 1,6 minutes 30% to 6 minutes 30%.
• Oulet to Relay.
• class II device
•- Indoore use
• Weigth: 25 gr.
Another presentation and model:
WITH PLATE AND FRAME
Code 0905
SEMI - ASSEMBLED (OEM)
Code 0975
CIRCUIT
Code 0979
Maximum power per model and load type:  
Warning
• Do not use with:
- Fluorescent tube.
- Dichroic lamps with not dimming
electronictransformer.
- Energy - efficient lamps.
- Discharge lamps.
- Mixer lamps.
Downloads: