Photocontrol
for DIN rail with
sensitivity and timing switch
1000 W
sensitivity and timing switch
1000 W
Code
0121
(Suitable
for any lamps)
- The model with sensitivity regulation allows adjusting at will the level of ambiance ligth (dusk).
- Suitable for use out of the dwelling house, in windows-shops, shelters, posters, signs, public way,aquares, factories.
- Sensitivity is regulated through a potenciometer placed in the front.
- Next fully automatic operation.
- The sensor should be placed outside so that it gets most of the daylight , it can be installed outdoors but vertically ( if not outdoors, it can be installed in any position).
- Both bodies should be joint by a bipolar conductor with no less than 0,75 mm section, suitably isolated.
- Before carrying out the installation,the general electric power switch of the entire premises must be shut off.
Maximum
power per load type:
-
Choose the number of hours the load will be on during the night based
on the following graph:
- From start
20 % to 25 ªC.
*TEMPORIZATION WITH WICH USINE DISPOSITIVE IS DELIVERED.
- From start
20 % to 25 ªC.*TEMPORIZATION WITH WICH USINE DISPOSITIVE IS DELIVERED.
Wiring
diagrams:
Technical
features:
| Warning   |
| • The light from any light appliance should be prevented from coming into contact with the photocontrol. |
Note:
The light appliance
should be kept away
from moisture and insects.
• Supply voltage: 220 V 
50 - 60 Hz.
• Schedule timing: 2,3,4,6,8 and 12 hours
20 % from start. ( when there is ligth, timing stops).
• Sensivility adjustment: 0,1 to 6000 Lux.
• Relay ouput.
• class II device
• Main body indoore use
• Sensor:
• outdoor use
IP 44.
• Weigth: 120 gr.
50 - 60 Hz.• Schedule timing: 2,3,4,6,8 and 12 hours
20 % from start. ( when there is ligth, timing stops). • Sensivility adjustment: 0,1 to 6000 Lux.
• Relay ouput.
• class II device
• Main body indoore use
• Sensor:
• outdoor use
IP 44.• Weigth: 120 gr.
Downloads: