BACK
Universal photocontrol with
programable Timed
 1000 W
Code 0107
(Suitable for any lamps)
220 Volt
Function: 
- It allows turning on a light appliance automatically and turning it off after a certain number of hours scheduled (this helps to save energy).
- Suitable for use out of the dwelling house, in windows-shops, shelters, posters, signs, public way,aquares, factories.
Operation:
- 6 hours are initially scheduled at the factory. The schedule can be modified by the installer through small switches inside.
Schedule of the timed
model Code 0107 :
 If it necessary to reschedule that time, do as follows:
1- To open the head, lever with a
screwdriver in the side cavity where the locks are.
2- Choose the number of hours the load will be on during the nigth based on the following graphs:
- the subsequent operation is fully automated.
Installation:
- Install within the proximity of the appliance to be controlled, but preventing the light from coming into contact with the photocontrol.
- It can be installed outdoors but vertically ( if not outdoors, it can be installed in any position).
- Before carrying out the installation,the general electric power switch of the entire premises must be shut off.
Maximum power per load type: 
 Technical features:  


- To control higher power a contactor should be used, with a photocontrol to supply the reel of the contactor.
• Supply voltage: 220 V 50 - 60 Hz.
• Schedule timing: 2,3,4,6,8 and 12 hours 15 % from start.
( when there is ligth, timing stops).
• Relay ouput.
• class II device
• outdoor use
• IP 44
• Weigth: 70 gr. 

Warning
• The light from any light appliance should be prevented from coming into contact with the photocontrol.


Note:
The light appliance should be kept away
from moisture and insects.
Wiring diagrams:

Downloads:
Download all the catalogue